|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | TENSILE STRENGTH AND CREEP RESISTANCE OF Mg-9Al-1Zn BASED ALLOYS WITH CALCIUM ADDITION显示文摘Small amount of calcium addition to the Mg-9A1-0.8Zn-0.2Mn (AZ91) alloy resulted in the obvious influence on mechanical properties. The yield strength of the alloys increased with the increase of Ca addition and maximum strength was obtained from the alloy containing 0.15% of Ca. The creep resistance at the temperatures between 150-200℃ was also significantly increased with Ca addition. The creep rate (at 200℃, 50MPa) of the alloy with00.15% of Ca addition was one order of magnitude lower than that of the base alloy (AZ91). Microstructural observations revealed that the addition of calcium refined the microstructure and enhanced the thermal stability of the β precipitates, which accounted for the improvement of creep resistance at high temperatures. | Y.S. Sun, W.M. Zhang and X.G. Mm Department of Materials Science and Engineering, Southeast University, Nanjing 210096, China | 2001 | Acta Metallurgica Sinica(English Letters)2001，14，5： | 12 |
| 2 | INTERACTION OF PRECIPITATION AND RECRYSTALLIZATION IN RAPIDLY SOLIDIFIED Cu-Cr-Zr-Mg ALLOY显示文摘In this paper; the recrystallization process during aging for a rapidly solidified Cu-Cr-Zr-Mg alloy has been investigated. It is found that the discotinuous crystallization process has been partially retarded by the ultra-fine and dispersed precipitation upon aging after deformation. Thus, a phenomenon of combined in situ and discontinuous recrystallization has been observed in the rapidly solidified Cu-Cr-Zr-Mg alloy.On the nucleation and growth of recrystallization, the precipitated phases are coarscned and dissolved in the front of grain boundaries following a re-precipitation in the recrystallization area,which results in the much more dispersed precipitates. | Liu, P. Kang, B.X. Cao, X.G. Huang, J.L. Yin, B. Gu, H.C. | 1999 | Acta Metallurgica Sinica(English Letters)1999，12，3： | 11 |
| 3 | A two-scale method for identifying mechanical parameters of composite materials with periodic configuration显示文摘在这篇论文,一个二规模的方法(TSM ) 为与小周期的配置识别象合成材料的僵硬和力量那样的力学参数被介绍。第一,明确的表达简短为合成材料的二规模的分析(TSA ) 被给。然后紧张和压力的二规模的计算明确的表达被排水量答案为三种如此的 composites 结构与 orthotropic 材料系数开发,即,有方形的生气的节,有矩形的生气的节的弯曲伸臂和有一个圆的扭转列的紧张列交叉节。为三种结构的力量公式被导出, TSM 过程被讨论。最后,僵硬和力量的数字结果被介绍并且与试验性的数据相比。它证明在这篇论文的 TSM 方法为与周期的配置预言僵硬和合成材料的力量可行、有效。 | J.Z. Cui X.G. Yu | 2006 | Acta Mechanica Sinica2006，22，6： | 9 |
| 4 | CREVICE CORROSION BEHAVIOR OF X70 STEEL IN HCO_3^- SOLUTION UNDER CATHODIC POLARIZATION显示文摘X70 钢的缝隙腐蚀行为与楔形的缝隙汇编 under-1000 mV ( SCE )被调查在有各种各样的HCO3- concentrations.The 潜力的解决方案的 cathodic 极化,当前,在缝隙以内的 pH 和氧内容被测量与或没有显示的在外面联合的 specimen.The 结果在缝隙的 X70 钢的极化潜力在 cathodic polarization.There 下面随时间的增加落下,这是HCO3- concen | C.W. Du X.G. Li X. Chen P. Liang H. Guo | 2008 | Acta Metallurgica Sinica(English Letters)2008，21，4： | 6 |
| 5 | ATOMIC SCALE MECHANISM OF RESTRAINED EMBRITTLEMENT IN AMORPHOUS Fe_(78)B_(13)Si_9 ALLOY BY ELECTRIC PULSE RAPID ANNEALING显示文摘The direct observations of the atomic arrangements in both conventional furnace annealed and electric pulse rapid annealed Fe78B13Si9 amorphous alloy have been conducted by the lattice imaging technique in a higt resolution electron microscope. The results showed that the embrittlement of the alloy was related to the extent of atomic rearrangements during the annealing processes. The embrittlement of the alloy after 1hour conventional furnace annealing at about 270℃ is caused by the sufficient atomic rearrangements which are characterized by the growth of some bct Fe3B-like atomic short range ordering regions already existed in the as-quenched structure. Electric pulse rapid annealing can effectively retard the above-mentioned atomic rearrangements and thus restrain the embrittlement. The embrittlement only occurs when certain amount of bcc α-Fe nanocrystals are precipitated in the amorphous matrix during electric pulse rapid annealing. | J.L. Huang X.G. Cao E. Sukedai S. Yamasaki and H.C.Gu(Department of Materials Engineering, Luoyang Institute of Technology, Luoyang 471039, China)(Department of Mechanical Engineering, Okayama University of Science, 1-1 Ridai-Cho,Okayama City,Okayma | 1998 | Acta Metallurgica Sinica(English Letters)1998，11，4： | 3 |
| 6 | CRYSTAL STRUCTURE AND ELECTROCHEMICAL PROPERTIES OF Zr(Mn_(1-x)Ni_x)_2(0.40≤x≤0.75) HYDROGEN STORAGE ALLOYS显示文摘The crystal structure, phase abundance and the electrochemical properties of Zr(Mn1-x Nix)2 (0.40 ≤x≤0.75) alloys were investigated by means of XRD, Rietveld refinement method and electrochemical measurements. The alloys are multiphase. C15 Laves phase occurs as a main phase accompanying with C14 phase and other minor phases, indicating that Ni element is C15-stabilized element for ZrMn2 alloy. The phase abundance and lattice parameters of Laves phase are influenced significantly by Ni substitution. The Zr(Mn0.45 Ni0.55)2 alloy with the highest amount of C15 phase exhibits the maximum electrochemical capacity of 242m Ah/g. C14 phase occurring in Zr-Mn-Ni alloys is beneficial for the electrochemical kinetics of hydride electrodes. | W.K. Zhang, C.A. Ma, X.G. Yang, H. Huang, Y.Q. Lei and Q.D. Wang (Department of Applied Chemistry, Zhejiang University of Technology, Hangzhou 310014, China Department of Materials Science and Engineering, Zhejiang University, Hangzhou 310027, China) | 2001 | Acta Metallurgica Sinica(English Letters)2001，14，1： | 3 |
| 7 | The clinical value of serum CEA, CA19-9, and CA242 in the diagnosis and prognosis of pancreatic cancer显示文摘 | X.G. Ni X.F. Bai Y.L. Mao Y.F. Shao J.X. Wu Y. Shan C.F. Wang J. Wang Y.T. Tian Q. Liu D.K. Xu P. Zhao | 2004 | European Journal of Surgical Oncology2004，，2： | 2 |
| 8 | Composite anode material of silicon/graphite/carbon nanotubes for Li-ion batteries显示文摘 | Y. Zhang X.G. Zhang H.L. Zhang Z.G. Zhao F. Li C. Liu H.M. Cheng | 2006 | Electrochimica Acta2006，，23： | 2 |
| 9 | Effect of microstructure and inclusions on hydrogen induced cracking susceptibility and hydrogen trapping efficiency of X120 pipeline steel显示文摘 | F. Huang J. Liu Z.J. Deng J.H. Cheng Z.H. Lu X.G. Li | 2010 | Materials Science & Engineering A2010，，26： | 2 |
| 10 | Internal-state-variable based self-consistent constitutive modeling for hot working of two-phase titanium alloys coupling microstructure evolution显示文摘 | X.G. Fan H. Yang | 2011 | International Journal of Plasticity2011，，11： | 2 |
| 11 | NEAR RAPID DIRECTIONAL SOLIDIFICATION AND ITS SUPERFINE MICROSTRUCTURE显示文摘NEARRAPIDDIRECTIONALSOLIDIFICATIONANDITSSUPERFINEMICROSTRUCTUREH.Z.Fu;X.G.Gen;J.G.LiandJ.Zhang(StateKeyLab.ofSolidificationPr... | H.Z. Fu X.G. Gen J.G. Li and J.Zhang(State Key Lab.of Solidification Processing, Northwestern Polytechnical University,Xi’an 710072,China ) | 1996 | Acta Metallurgica Sinica(English Letters)1996，9，6： | 2 |
| 12 | Influence of pores on the thermal insulation behavior of thermal barrier coatings prepared by atmospheric plasma spray显示文摘 | L. Wang Y. Wang X.G. Sun J.Q. He Z.Y. Pan Y. Zhou P.L. Wu | 2010 | Materials and Design2010，，1： | 2 |
| 13 | KINETIC MODEL FOR POWDER INJECTION DESULFURIZATION显示文摘The kinetic model for desulfurization using CaO-based powder injection has been proposed, which accords with the actual process of the experiment. For the model, a comparison between CaO-based flux and Mg-based flux was made and the results show that the desulfurization rate of the Mg-based flux is far more than that of CaO-based flux. On the basis of the model calculation, on comparison of CaO-CaF2 flux and calcium aluminate flux, the desulfurization rates of the two fluxes are close to each other. In addition, the effects of some operational factors on the kinetics of desulfurization are discussed. | Y. Jin X.G. Bi S.R. Yu | 2006 | Acta Metallurgica Sinica(English Letters)2006，19，4： | 2 |
| 14 | Finite element simulation of residual stress of double-ceramic-layer La 2 Zr 2 O 7 /8YSZ thermal barrier coatings using birth and death element technique显示文摘 | L. Wang Y. Wang X.G. Sun J.Q. He Z.Y. Pan C.H. Wang | 2011 | Computational Materials Science2011，，1： | 1 |
| 15 | Biophysical regulations of carbon fluxes of a steppe and a cultivated cropland in semiarid Inner Mongolia显示文摘 | W.L. Zhang S.P. Chen J. Chen L. Wei X.G. Han G.H. Lin | 2007 | Agricultural and Forest Meteorology2007，，3： | 1 |
| 16 | Mechanistic aspect of near-neutral pH stress corrosion cracking of pipelines under cathodic polarization显示文摘 | Z.Y. Liu X.G. Li Y.F. Cheng | 2011 | Corrosion Science2011，，： | 1 |
| 17 | Some advanced plastic processing technologies and their numerical simulation显示文摘 | H. Yang M. Zhan Y.L. Liu F.J. Xian Z.C. Sun Y. Lin X.G. Zhang | 2004 | Journal of Materials Processing Tech2004，，1： | 1 |
| 18 | Adsorption of methyl orange and Cr(VI) on mesoporous TiO 2 prepared by hydrothermal method显示文摘 | S. Asuha X.G. Zhou S. Zhao | 2010 | Journal of Hazardous Materials2010，，1： | 1 |
| 19 | Microwave absorption properties of the core/shell-type iron and nickel nanoparticles显示文摘 | B. Lu X.L. Dong H. Huang X.F. Zhang X.G. Zhu J.P. Lei J.P. Sun | 2007 | Journal of Magnetism and Magnetic Materials2007，，6： | 1 |
| 20 | One-step synthesis of Cu(In,Ga)Se 2 absorber layers by magnetron sputtering from a single quaternary target显示文摘 | A.J. Zhou D. Mei X.G. Kong X.H. Xu L.D. Feng X.Y. Dai T. Gao J.Z. Li | 2012 | Thin Solid Films2012，，19： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员