| 1 | Oxidation,Mechanical and Tribological Behaviors of the Ni/cBN Abrasive Coating-Coated Titanium Alloys显示文摘In order to improve the oxidation and wear resistance of blades tip of titanium alloys as well as the sealing performance of the gas turbine engine,a Ni/cBN abrasive coating was prepared on titanium alloys through composite electroplating.Oxidation,mechanical and tribological properties of the abrasive coating were investigated.Furthermore,the effect of the oxidation on the mechanical and tribological properties was also evaluated.Oxidation results revealed that the abrasive coating underwent slight oxidation within 700℃.Meanwhile,some intermetallic compounds,Ni3Ti,NiTi and NiTi2,were formed at the coating/substrate interface during oxidation.Due to the pinning effect of cBN particles and the different thermal expansion coefficients of the coating and substrate,the coating/substrate interface was cracked after oxidation at 700℃.Tensile results showed that the presence of coating reduced the strength of the alloy significantly at room temperature,while only marginal variations of the strength of the coated and uncoated specimens at elevated temperatures.Besides,the wear tests indicated that the coating had the excellent cutting ability and wear resistance,which can effectively protect the blades tip of titanium alloys.As the temperature increased,the wear resistance decreased due to the decrease in the mechanical properties of the Ni/cBN coating. | Y.D.Liu J.H.Liu W.S.Gu H.L.Li W.H.Li Z.L.Pei J.Gong C.Sun | 2021 | Acta Metallurgica Sinica(English Letters)2021，34，7： | 4 |
| 4 | Corrosion and cavitation erosion resistance enhancement of cast Ni–Al bronze by laser surface melting显示文摘Laser surface melting (LSM) was applied on a cast Ni–Al bronze (NAB), which was a crucial material for marine ship propellers. A 720 μm-thick LSM layer with fine equiaxed and dendritic microstructures was obtained. After immersion for 30 days, the corrosion rate of cast NAB was reduced by 25% after LSM. Preferential corrosion occurred and deep corrosion pits appeared at α + κIII microstructure for the cast NAB. LSM NAB underwent general corrosion, and a much more protective film formed on the surface because of the homogenized microstructure. The mass loss of the cast NAB was approximately 2.1 times larger than that of LSM NAB after cavitation erosion (CE) in 3.5 wt.% NaCl solution for 5 h. For the two materials, the mechanical impact effect was dominantly responsible for CE damage. Therefore, the improved hardness and homogenized microstructure contributed to the improved CE resistance of LSM NAB. CE destructed the film, shifted the open circuit potential toward a more negative value, and raised the current density by an order of magnitude. Corrosion at the cast eutectoid microstructure and the dendrites of LSM NAB facilitates the degradation under the cavitation attack. CE-corrosion synergy was largely caused by corrosion-enhanced-CE. | Q.N.Song Y.Tong H.L.Li H.N.Zhang N.Xu G.Y.Zhang Y.F.Bao W.Liu Z.G.Liu Y.X.Qiao | 2022 | Journal of Iron and Steel Research(International)2022，29，2： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员