|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Directly Draw- ing Self-Assembled, Porous, and Monolithic Graphene Fiber from Chemical Vapor Deposition Grown Graphene Film and Its Electro- chemical Properties显示文摘 | Li Xinming Zhao Tianshuo Wang Kunlin | 2011 | Langmuir2011，27，12： | 1 |
| 2 | Completely spin-decoupled geometric phase of a metasurface显示文摘Metasurfaces have provided an unprecedented degree of freedom(DOF)in the manipulation of electromagnetic waves.A geometric phase can be readily obtained by rotating the meta-atoms of a metasurface.Nevertheless,such geometric phases are usually spin-coupled,with the same magnitude but opposite signs for left-and right-handed circularly polarized(LCP and RCP)waves.To achieve independent control of LCP and RCP waves,it is crucial to obtain spin-decoupled geometric phases.In this paper,we propose to obtain completely spin-decoupled geometric phases by engineering the surface current paths on meta-atoms.Based on the rotational Doppler effect,the rotation manner is first analyzed,and it is found that the generation of a geometric phase lies in the rotation of the surface current paths on meta-atoms.Since the induced surface current paths under the LCP and RCP waves always start oppositely and are mirror-symmetrical with each other,it is natural that the geometric phases have the same magnitude and opposite signs when the meta-atoms are rotated.To obtain spin-decoupled geometric phases,the induced surface current under one spin should be rotated by one angle while the current under the other spin is rotated by a different angles.In this way,LCP and RCP waves can acquire different geometric phase changes.Proof-of-principle prototypes were designed,fabricated,and measured.Both the simulation and experiment results verify spin-decoupled geometric phases.This work provides a robust means to obtain a spindependent geometric phase and can be readily extended to higher frequency bands such as the terahertz,IR,and optical regimes. | XINMIN FU JIE YANG JIAFU WANG YAJUAN HAN CHANG DING TIANSHUO QIU BINGYUE QU LEI LI YONGFENG LI SHAOBO QU | 2023 | Photonics Research2023，11，7： | 1 |
| 3 | FISH-based “pan” and “core” karyotypes reveal genetic diversification of Roegneria ciliaris显示文摘The genus Roegneria was firstly established with Roegneria caucasica C.Koch as the model species.Being the largest genera in the tribe Triticeae(Poaceae),Roegneria includes 130 species mainly distributed in the north temperate zone.There are 70 Roegneria species and 22 variants,which are widely distributed in different regions of China(Lei,2018).The diversified morphology of Roegneria species has caused controversy in their taxonomy.It has been argued whether Roegneria species should be included in the genus Elymus or considered as an independent genus(Lei et al.,2018).The investigation of the cytological and genomic feature would help to clarify the taxonomic placement of Roegneria. | Menghao Cheng Xingyue Li Huimin Cui Haojie Sun Tianshuo Deng Xinying Song Rongrong Song Tong Wang Zongkuan Wang Haiyan Wang Xiue Wang | 2023 | Journal of Genetics and Genomics2023，50，2： | 1 |
| 4 | Remotely mind-controlled metasurface via brainwaves显示文摘The power of controlling objects with mind has captivated a popular fascination to human beings.One possible path is to employ brain signal collecting technologies together with emerging programmable metasurfaces(PM),whose functions or operating modes can be switched or customized via on-site programming or pre-defined software.Nevertheless,most of existing PMs are wire-connected to users,manually-controlled and not real-time.Here,we propose the concept of remotely mind-controlled metasurface(RMCM)via brainwaves.Rather than DC voltage from power supply or AC voltages from signal generators,the metasurface is controlled by brainwaves collected in real time and transmitted wirelessly from the user.As an example,we demonstrated a RMCM whose scattering pattern can be altered dynamically according to the user’s brain waves via Bluetooth.The attention intensity information is extracted as the control signal and a mapping between attention intensity and scattering pattern of the metasurface is established.With such a framework,we experimentally demonstrated and verified a prototype of such metasurface system which can be remotely controlled by the user to modify its scattering pattern.This work paves a new way to intelligent metasurfaces and may find applications in health monitoring,5G/6G communications,smart sensors,etc. | Ruichao Zhu Jiafu Wang Tianshuo Qiu Yajuan Han Xinmin Fu Yuzhi Shi Xingsi Liu Tonghao Liu Zhongtao Zhang Zuntian Chu Cheng‑Wei Qiu Shaobo Qu | 2022 | eLight2022，2，1： | 1 |
| 5 | Directly Drawing Self-Assembled, Porous, and Monolithic Graphene Fiber from Chem- ical Vapor Deposition Grown Graphene Film and Its Electrochemical Properties 显示文摘 | Xinming Li Tianshuo Zhao Kunlin Wang | 2011 | Langmuir2011，27，12： | 1 |
| 6 | Direct field-to-pattern monolithic design of holographic metasurface via residual encoderdecoder convolutional neural network显示文摘Complex-amplitude holographic metasurfaces(CAHMs)with the flexibility in modulating phase and amplitude profiles have been used to manipulate the propagation of wavefront with an unprecedented level,leading to higher image-reconstruction quality compared with their natural counterparts.However,prevailing design methods of CAHMs are based on Huygens-Fresnel theory,meta-atom optimization,numerical simulation and experimental verification,which results in a consumption of computing resources.Here,we applied residual encoder-decoder convolutional neural network to directly map the electric field distributions and input images for monolithic metasurface design.A pretrained network is firstly trained by the electric field distributions calculated by diffraction theory,which is subsequently migrated as transfer learning framework to map the simulated electric field distributions and input images.The training results show that the normalized mean pixel error is about 3%on dataset.As verification,the metasurface prototypes are fabricated,simulated and measured.The reconstructed electric field of reverse-engineered metasurface exhibits high similarity to the target electric field,which demonstrates the effectiveness of our design.Encouragingly,this work provides a monolithic field-to-pattern design method for CAHMs,which paves a new route for the direct reconstruction of metasurfaces. | Ruichao Zhu Jiafu Wang Tianshuo Qiu Dingkang Yang Bo Feng Zuntian Chu Tonghao Liu Yajuan Han Hongya Chen Shaobo Qu | 2023 | Opto-Electronic Advances2023，6，8： | 0 |
| 7 | Influence of Cavity Leakage flow on Corner Separation in a Shrouded Stator Cascade显示文摘The impacts of the cavity leakage flow on the shrouded stator aerodynamic performance were investigated by modelling the annular cascade mainstream with the seal cavity flow path based on the validated numerical method.Meanwhile,the interactions between the cavity leakage and the mainstream were also determined in the current study.The development of hub corner separation under the action of leakage was discussed and the total pressure loss coefficient as well as the entropy-based loss coefficient was employed to evaluate the performance changes at different seal clearances and cavity rotational speeds.The results show that the cavity leakage flow induces a new vortex near the blade leading edge and plays an important role in the development of passage vortex and the size of concentrated shedding vortex.By increasing the seal clearance with more cavity leakage flow rate,an increase in the pitchwise extent of the separation region under 15%span is significant and the total pressure loss in the separation core increases.In addition,with the increase of cavity rotating speed,the starting point of corner separation moves backward,reducing the size and depth of the hub corner separation.The mainstream loss reduction in combination with the entropy increase in the seal cavity causes the entropy-based loss coefficient to perform a trend of decreasing first and then increasing with the cavity speed. | KONG Xiaozhi HUANG Tianshuo LIU Yuxin LU Huawei WANG Long | 2023 | Journal of Thermal Science2023，32，1： | 0 |
| 8 | Atomically Dispersed Iron Active Sites Promoting Reversible Redox Kinetics and Suppressing Shuttle Effect in Aluminum-Sulfur Batteries显示文摘Rechargeable aluminum-sulfur(Al-S)batteries have been considered as a highly potential energy storage system owing to the high theoretical capacity,good safety,abundant natural reserves,and low cost of Al and S.However,the research progress of Al-S batteries is limited by the slow kinetics and shuttle effect of soluble polysulfides intermediates.Herein,an interconnected free-standing interlayer of iron sin-gle atoms supported on porous nitrogen-doped carbon nanofibers(FeSAs-NCF)on the separator is developed and used as both catalyst and chemical barrier for Al-S batteries.The atomically dispersed iron active sites(Fe-N_(4))are clearly identified by aberration-corrected high-angle annular dark-field scanning transmission electron microscopy and X-ray absorption near-edge structure.The Al-S battery with the FeSAs-NCF shows an improved specific capacity of 780 mAh g^(−1)and enhanced cycle stability.As evidenced by experimental and theoretical results,the atomically dispersed iron active centers on the separator can chemically adsorb the polysulfides and accelerate reaction kinetics to inhibit the shuttle effect and promote the reversible conversion between aluminum polysulfides,thus improving the electrochemical performance of the Al-S battery.This work provides a new way that can not only promote the conversion of aluminum sulfides but also suppress the shuttle effect in Al-S batteries. | Fei Wang Min Jiang Tianshuo Zhao Pengyu Meng Jianmin Ren Zhaohui Yang Jiao Zhang Chaopeng Fu Baode Sun | 2022 | Nano-Micro Letters2022，14，10： | 0 |
| 9 | Rational design of vitamin C/defective carbon van der Waals heterostructure for enhanced activity,durability and storage stability toward oxygen reduction reaction显示文摘Metal-free defective carbon materials with abundant active sites have been widely studied as low-cost and efficient oxygen reduction reaction(ORR)electrocatalysts in metal-air batteries.However,the active sites in defective carbon are easily subjected to serious oxidation or hydroxylation during ORR or storage,leading to rapid degradation of activity.Herein,we design a van der Waals heterostructure comprised of vitamin C(VC)and defective carbon(DC)to not only boost the activity but also enhance the durability and storage stability of the DC-VC electrocatalyst.The formation of VC van der Waals between DC and VC is demonstrated to be an effective strategy to protect the defect active sites from oxidation and hydroxylation degradation,thus significantly enhancing the electrochemical durability and storage anti-aging performance.Moreover,the DC-VC van der Waals can reduce the reaction energy barrier to facilitate the ORR.These findings are also confirmed by operando Fourier transform infrared spectroscopy and density functional theory calculations.It is necessary to mention that the preparation of this DC-VC electrocatalyst can be scaled up,and the ORR performance of the largely produced electrocatalyst is demonstrated to be very consistent.Furthermore,the DC-VC-based aluminum-air batteries display very competitive power density with good performance maintenance. | Ruiqi Cheng Kaiqi Li Huanxin Li Tianshuo Zhao Yibo Wang Qingyue Xue Jiao Zhang Chaopeng Fu | 2024 | Journal of Energy Chemistry2024，88，1： | 0 |
| 10 | Six-channel programmable coding metasurface simultaneously for orthogonal circular and linear polarizations显示文摘Metasurfaces have intrigued long-standing research interests and developed multitudinous compelling applications owing to their unprecedented capability for manipulating electromagnetic waves,and the emerging programmable coding metasurfaces(PCMs)provide a real-time reconfigurable platform to dynamically implement customized functions.Nevertheless,most existing PCMs can only act on the single polarization state or perform in the limited polarization channel,which immensely restricts their practical application in multitask intelligent metadevices.Herein,an appealing strategy of the PCM is proposed to realize tunable functions in co-polarized reflection channels of orthogonal circularly polarized waves and in co-polarized and cross-polarized reflection channels of orthogonal linearly polarized waves from 9.0 to 10.5 GHz.In the above six channels,the spindecoupled programmable meta-atom can achieve high-efficiency reflection and 1-bit digital phase modulation by selecting the specific ON/OFF states of two diodes,and the phase coding sequence of the PCM is dynamically regulated by the field-programmable gate array to generate the desired function.A proof-of-concept prototype is constructed to verify the feasibility of our methodology,and numerous simulation and experimental results are in excellent agreement with the theoretical predictions.This inspiring design opens a new avenue for constructing intelligent metasurfaces with higher serviceability and flexibility,and has tremendous application potential in communication,sensing,and other multifunctional smart metadevices. | TONGHAO LIU YUEYU MENG JIAFU WANG HUA MA RUICHAO ZHU CHAO LIU WEIHAN LI ZUNTIAN CHU SAI SUI TIANSHUO QIU WENXUAN TANG SHAOBO QU | 2023 | Photonics Research2023，11，6： | 0 |
| 11 | A Rhythmic Motion Control Method Inspired by Board Shoe Racing for a Weight-Bearing Exoskeleton显示文摘To ensure the flexible walking of the weight-bearing exoskeleton robot,most researchers control the exoskeleton to follow the wearer’s movements and provide force to maintain the current dynamic state.However,due to the limitation of sensing information and computing power,it is difficult for the exoskeleton to provide the wearer reasonable and stable force only based on the dynamic model,especially in switching between swing phase and stance phase.Inspired by China’s traditional sport named board shoe racing,a walking control method based on the cooperation of the human and the exoskeleton is proposed in this paper for a lower-limb exoskeleton named PALExo.Under certain conditions,the exoskeleton itself can walk stably depending on the rhythm signals generated by the Central Pattern Generator(CPG).With certain initiative during walking,it can make proper adjustments according to the human movement.With the help of dynamic simulation software and Genetic Algorithm(GA),the optimized CPG parameters are obtained.Impedance control is introduced to increase the comfort of the wearer.The impedance parameters as well as the CPG parameters are tuned in real time based on feedback.The experiments were conducted with PALExo.The results demonstrate that PALExo can effectively assist the wearer walking with a 45-kg payload benefiting from the proposed method. | Tianshuo Wang Jie Zhao Dongbao Sui Sikai Zhao Yanhe Zhu | 2022 | Journal of Bionic Engineering2022，19，2： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员