| 3 | UltrahighQ Sr_(1+x)Y_(2)O_(4+x)(x=0-0.04)microwave dielectric ceramics for temperature-stable millimeter-wave dielectric resonator antennas显示文摘Microwave dielectric ceramics should be improved to advance mobile communication technologies further.In this study,we prepared Sr_(1+x)Y_(2)O_(4+x)(x=0-0.04)ceramics with nonstoichiometric Sr^(2+)ratios based on our previously reported SrY_(2)O_(4) microwave dielectric ceramic,which has a low dielectric constant and an ultrahigh quality factor(Q value).The ceramic exhibited a 33.6% higher Q-by-frequency(Q×f)value(Q≈12,500)at x=0.02 than SrY_(2)O_(4).All Sr_(1+x)Y_(2)O_(4+x)(x=0-0.04)ceramics exhibited pure phase structures,although variations in crystal-plane spacings were observed.The ceramics are mainly composed of Sr-O,Y1-O,and Y_(2)-O octahedra,with the temperature coefficient of the resonant frequency(τ_(f))of the ceramic increasing with Y_(2)-O octahedral distortion.The ceramic comprises uniform grains with a homogeneous elemental distribution,clear grain boundaries,and no obvious cavities at x=0.02.The Sr_(1+x)Y_(2)O_(4+x)(x=0-0.04)ceramics exhibited good microwave dielectric properties,with optimal performance observed at x=0.02(dielectric constant(εr)=15.41,Q×f=112,375 GHz,and τ_(f)=-17.44 ppm/℃).The τ_(f) value was reduced to meet the temperaturestability requirements of 5G/6G communication systems by adding CaTiO_(3),with Sr_(1.02)Y_(2)O_(4.02)+2wt% CaTiO_(3) exhibiting ε_(r)=16.14,Q×f=51,004 GHz,andτf=0 ppm/℃.A dielectric resonator antenna prepared using Sr_(1.02)Y_(2)O_(4.02)+2wt%CaTiO_(3) exhibited a central frequency of 26.6 GHz,with a corresponding gain and efficiency of 3.66 dBi and 83.14%,respectively.Consequently,Sr_(1.02)Y_(2)O_(4).02-based dielectric resonator antennas are suitable for use in 5G millimeter-wave band(24.5-27.5 GHz)applications. | Guoqiang He Yu Jiang Kaixin Song Yanjun Liu Yuan Nie Wenjie Zhang Ziqi Zhao Yinghan He Xinyue Ma Xiuli Chen Xu Li Huanfu Zhou | 2024 | Journal of Advanced Ceramics2024，13，2： | 0 |
| 4 | Effect of polymer structures on electro-optical properties of polymer stabilized liquid crystal films显示文摘The polymer stabilized liquid crystal(PSLC)film is a relatively novel electro-optical material,which is generally obtained by dissolving a small amount of a bifunctional photoreactive monomer in a low molecular mass liquid crystal.In this paper,the PSLC films were prepared with photoreactive biphenyl methacrylate monomers by photopolymerization induced phase separation.The effects of liquid crystal concentration,curing time,monomer structures and alignment layer on the electro-optical properties of PSLC films were investigated.The results show that the transmittance in the OFF state(TOFF)increased with the liquid crystal concentration,but the driving voltage decreased.TOFF was also influenced by the curing time.Furthermore,when polyimide was used as alignment layer,the films prepared from the bifunctional monomer shows a higher TOFF,while those from the single functional monomer exhibited a deformed electro-optical curve due to the unsteady polymer networks. | Shoulian WANG Jie HE Yu ZENG Bin YAN Yinghan WANG | 2008 | Frontiers of Chemical Science and Engineering2008，2，3： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员