|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Effect of Testing Conditions on Fibre-Bundle Tensile Properties-Part Ⅱ: the Gauge Length and Elongation Speed in Wool Fibre Bundle Measurement显示文摘The testing conditions of a fibre bundle tensile tester (TENSOR) are elongation speed (ES), gauge length (GL), pretension, jaw pressure, environmental temperature and relative humidity, instrument linearity and sensitivity. The effects on fibre-bundle tensile properties at different GL and ES have been discussed in detail and compared with Peirce’s theories on the weaklinks and the breaking time effect. The experimental results indicate that the tensile properties of fibre bundles are strongly affected by GL and vary with different GL. The reasonable GL should be 5 15 mm rather than 3.2 mm for wool bundle measurements. The ES ranging from 20 mm/min to 40 mm/min is beneficial for obtaining comparatively stable and accurate tensile values, whereas 20 mm/min used in current testing for wool fibre bundles is at the lower limit of the suggested range. For bundle modulus measurement, the sampling interval must be selected appropriately. The new calculation of the sampling interval has been established. | 于伟东 Ron Postle 杨守仁 严灏景 | 2002 | Journal of Donghua University(English Edition)2002，19，3： | 3 |
| 2 | 表面纤维直径与羊毛机织精纺面料的刺痒感显示文摘通过前臂试验对26种轻薄型羊毛机织精纺面料和7种其他纤维的轻薄型机织面料的刺痒感进行了比较研究,并用显微镜对部分轻薄型羊毛机织面料的表面纤维分布进行了研究。结果表明多数毛织物在温度为(24±1)℃、相对湿度为(65±5)%的条件下存在刺痒感,并且毛织物的刺痒感与其表面纤维的平面直径及直径大于26μm的表面纤维根数密切相关。 | 王革辉 张渭源 王花娥 Ron Postle | 2004 | 东华大学学报(自然科学版)2004，30，1： | 3 |
| 3 | Effect of Testing Conditions on Fibre-Bundle Tensile Properties Part Ⅰ: Sample Preparation, Bundle Mass and Fibre Alignment of Wool Bundles显示文摘Due to the effects of samples and testing conditions on fibre-bundle tensile behaviour, it is necessary to investigate the relationships between experimental factors and tensile properties for the fibre-bundle tensile tester (TENSOR). The effects of bundle sample preparation, fibre bundle mass and fibre alignment have been tested. The experimental results indicated that (1) the low damage in combing and no free-end fibres in the cut bundle are most important for the sample preparation; (2) the reasonable bundle mass is 400700 tex, but the tensile properties measured should be modified with the bundle mass because a small amount of bundle mass causes the scatter results, while the larger is the bundle mass, the more difficult to comb fibres parallel and to clamp fibre evenly; and (3) the fibre irregular arrangement forms a slack bundle resulting in interaction between fibres, which will affect the reproducibility and accuracy of the tensile testing. | 于伟东 严灏景 Ron Postle Yang Shouren | 2002 | Journal of Donghua University(English Edition)2002，19，2： | 3 |
| 4 | Comfort of Light-weight Wool and Wool Blend Woven Fabrics显示文摘The comfort of the light-weight woven fabrics was investigated by conducting the wear trials under the controlled climatic conditions. The wear trial under the neutral environmental conditions showed that the lightweight wool and wool blend fabrics are generally less comfortable than the silk fabric, cotton poplin and polyester/cotton poplin fabrics tested in this study. The main shortcoming in terms of comfort for these lightweight wool fabrics is the prickle. Besides, the fabric softness was found to be a very important factor influencing the comfort of the clothing worn next to the skin. | 王革辉 张渭源 Postle Ron | 2002 | Journal of Donghua University(English Edition)2002，19，4： | 2 |
| 5 | Direct numerical simulation of turbulent flow separation from a wall-mounted hump 显示文摘 | Postl D Fasel H F | 2006 | AIAA J2006，44，2： | 1 |
| 6 | Probing phospholipid dynamics by electrospray ionisation mass spectrometry显示文摘 | Postle AD Wilton DC Hunt AN | 2007 | Prog Lipid Res2007，46，34： | 1 |
| 7 | Analytical Algorithms for the Blend Ratios by Fibre-bundle Tensile Curves Part Ⅱ: Calculations of the Modulus Method and the Percentage Method显示文摘The principles for the modulus method and the percentage method are established and discussed in the part following Part Ⅰ of the series papers, in which we proposed the various algorithms of the strength method and the work method. The samples of Wool/PET blended fibre bundles, the method of fibre-bundle tensile tests and the typical specific stress-extension curves from the fibre bundles with different blend ratios are the same as in Part Ⅰ. It can be found that the theoretical results estimated by the modulus and percentage methods accord with the experimental values highly though the calculations of the two methods are slightly more complex than those of the strength and work methods. Especially, using the modulus method can not only avoid the influence of the error caused by the determination of the tensile curve of no fibre breaking in stretching, Y(e), but also need not to know the tensile curves of mono-component fibre bundles in certain calculation. The latter advantage of the modulus method exists in the percentage method too, but it should adopt the improved calculation of ones. | 于伟东 Ron Postle 严灏景 | 2004 | Journal of Donghua University(English Edition)2004，21，4： | 1 |
| 8 | Mechanics of three-dimensional braided structures for composite materials 11 : Predicton of the elastic moduli 显示文摘 | Tang Z X Postle R | 2001 | Composite Structures2001，51，： | 1 |
| 9 | Mechanics of three-dimensionalbraided structures for composite materials-Part Ⅲ:Nolinear finite element deformation analysis显示文摘 | TANG Z X POSTLE R | 2001 | Composite Structures2001，51，4： | 1 |
| 10 | Mechanics of three-dimensional braided structures for composite materials-part II:prediction of the elastic moduli显示文摘 | TANG Z X POSTLE R | 2001 | Compos Struct2001，51，： | 1 |
| 11 | Acute respiratory distress synyndrome and acute lung injury显示文摘 | Dushianthan A Grocott MP Postle AD | | 0，，1031： | 1 |
| 12 | Textile and apparel supply chain management in Hong Kong显示文摘 | Lam J K C Postle R | 2006 | International Journal of Clothing Science&Technology2006，18，4： | 1 |
| 13 | Removing pectin and lignin during chemical processing of hemp for textile applications显示文摘 | WANG H M POSTLE R KESSLER R W | 2003 | Textile Research Journal2003，73，8： | 1 |
| 14 | Fabric objective measurement (4): Production control in apparel manufacture显示文摘 | | 1989 | Textile Asia1989，，6： | 1 |
| 15 | Acute respiratory distress syndrome and acute lung injury 显示文摘 | Dushianthan A Grocott MPW Postle AD | 2011 | Postgrad Med J2011，87，6： | 1 |
| 16 | Functional neuro- anatomical double dissociation of mnemonic and executive control processes contributing to working memory perform- ance 显示文摘 | Postle BR Berger JS D'Esposito M | 1999 | Proc Natl Acad Sci USA1999，96，1： | 1 |
| 17 | Mechanics of three-dimensional braided structures for composite materials – part III: nonlinear finite element deformation analysis显示文摘 | Z.X. Tang R. Postle | 2002 | Composite Structures2002，，3： | 1 |
| 18 | Hygral expansion of woven wool fabrics显示文摘 | R Postle T I Mahar | 1985 | Textile Research Journal1985，，1： | 1 |
| 19 | Mechanics of three-dimensional braided structures for composite materials – Part II: prediction of the elastic moduli显示文摘 | Z.X. Tang R. Postle | 2001 | Composite Structures2001，，4： | 1 |
| 20 | Mechanics of three-dimensional braided structures for composite materials – part I: fabric structure and fibre volume fraction显示文摘 | Z.X Tang R Postle | 2000 | Composite Structures2000，，4： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员