|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Experimental study on microcapsule fluid oscillating heat pipe显示文摘In this experiment,a four-turn oscillating heat pipe(OHP)is made of copper tube with an inner diameter of 1.3mm,and an outer diameter of 2.5mm.A series of experiments are performed to investigate the startup characteristics of OHP,and the effects of different working fluids(FS-39E microcapsule fluid,pure water,ethanol),different liquid filling rates(40%-80%)on the heat transport capability of OHP in vertical bottom heat mode.The results show that the startup of OHP is relative with liquid filling rate,thermal driving force and working fluid;and experiences different flow patterns with the increase of heat load.The best concentration of FS-39E microcapsule fluid is 1wt%.While FS-39E microcapsule fluid is used as the working fluid,compared with pure water and ethanol,the OHP has a broader working scope;when the liquid filling rate is relatively high,the OHP shows a better performance on the startup and heat transport capability. | LIN ZiRong WANG ShuangFeng ZHANG WeiBao | 2009 | Science China(Technological Sciences)2009，52，6： | 5 |
| 2 | Numerical study on effects of the cofferdam area in liquefied natural gas storage tank on the leakage and diffusion characteristics of natural gas显示文摘The leakage and diffusion characteristics of natural gas were investigated in the condition of the leakage of liquefied natural gas(LNG) in the storage tank.Fluent was adopted to simulate the process in a series of three-dimension unsteady state calculations.The effects of different heights of the cofferdam(1.0 m, 2.0 m and 3.0 m),wind directions,ambient temperature,leakage location,leakage volume on the diffusion process of natural gas were investigated.The diffusion characteristics of the natural gas clouds over cofferdam were found.Under windless condition,when the gas clouds met,the gas clouds rose due to the collision,which made them easier to cross the cofferdam and spread out.The higher the ambient temperature was,the higher the gas concentration around the cofferdam was,and the smaller the gas concentration difference was.When the leakage occurred,the higher coffe rdam was more beneficial to delay the outward diffusion of gas clouds.However,when the leaka ge stopped,the higher cofferdam went against the dissipation of gas clouds.Under windy condition,the time to form stable leakage flow field was faster than that of windless,and the lower cofferdam further reduced this time.Therefore,considering the effect of barrier and dissipation,it was suggested that the rational height of cofferdam should be designed in the range of 1.0 m to 2.0 m.In case of emergency,the leakage of gas should be deduced reasonably by combining the measurement of gas concentration with the rolling of gas clouds.When windless,the leakage area should be entered between the overflows of gas clouds. | Zirong Lin Shuangfeng Wang Shuxun Fu Jiepeng Huo | 2021 | Chinese Journal of Chemical Engineering2021，34，1： | 2 |
| 3 | Simulation of a miniature oscillating heat pipe in bottom heating mode using CFD with unsteady modeling显示文摘 | LIN Zirong WANG Shuangfeng Ryo Shirakashi L | 2013 | International Journal of Heat and Mass Transfer2013，57，： | 1 |
| 4 | Heattransfer characteristics and LED heat sink application ofaluminum plate oscillating heat pipes 显示文摘 | Zirong Lin Shuangfeng Wang Jiepeng Huo | 2011 | AppliedThermal Engineering2011，，31： | 1 |
| 5 | UV surface exposure for low temperature hydrophilic silicon di- rect bonding 显示文摘 | Xiaohui Lin Guanglan Liao Zirong Tang Tielin Shi | 2009 | Microsystem Technologies2009，15，： | 1 |
| 6 | Development of conductive hydrogels: from design mechanisms to frontier applications显示文摘Owing to their excellent mechanical flexibility, electrical conductivity, and biocompatibility, conductive hydrogels(CHs) are widely used in the fields of energy and power, and biomedical technology. To arrive at a better understanding of the design methods and development trends of CHs, this paper summarizes and analyzes related research published in recent years. First,we describe the properties and characteristics of CHs. Using Scopus, the world’s largest abstract and citation database, we conducted a quantitative analysis of the related literature from the past 15 years and summarized development trends in the field of CHs. Second, we describe the types of CH network crosslinking and basic functional design methods and summarize the three-dimensional(3D) structure-forming methods and conductive performance tests of CHs. In addition, we introduce applications of CHs in the fields of energy and power, biomedical technology, and others. Lastly, we discuss several problems in current CH research and introduce some prospects for the future development of CHs. | Yang Hong Zening Lin Zirong Luo Tao Jiang Jianzhong Shang Yun Yang | 2022 | Bio-Design and Manufacturing2022，5，4： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员