| 1 | Improved mechanical properties of SiC fiber reinforced silica-based ceramic cores fabricated by stereolithography显示文摘Silica-based ceramic cores have been widely used to fabricate aero-engine hollow blades due to their moderate high temperature mechanical properties and excellent leachability.In this study,silica-based ceramics with SiC fiber addition were prepared via stereolithography,and the influence of SiC fiber content on mechanical properties of the obtained silica-based ceramics was investigated.With the increase of SiC fiber content,linear shrinkage gradually decreased,while room temperature flexural strength and high temperature flexural strength first increased and then decreased.As SiC fiber content increased to 4.0 wt%,linear shrinkage was reduced to 0.62%resulting from the oxidation of SiC.Furthermore,room temperature flexural strength was improved from 11.79 MPa to 23.83 MPa and high temperature flexural strength was enhanced from 15.64 MPa to 34.62 MPa with 4.0 wt%SiC fiber addition due to the reinforcement of fibers and the enhancedβ-cristobalite content,which meets the need of ceramic cores.Therefore,it demonstrates the capability of fabricating high-performance and high-precision silica-based ceramic cores reinforced by SiC fibers via stereolithography for rapid manufacturing of hollow blades. | W.Zheng J.M.Wu S.Chen K.B.Yu J.Zhang Y.S.Shi | 2022 | Journal of Materials Science & Technology2022，，21： | 2 |
| 2 | IGNITING SHS BY LASER AND ITS APPLICATION TO SELECTIVE LASER SINTERING OF METALLIC POWDER MATERIAL显示文摘How to directly fabricate metallic functional parts with selective laser sintering (SLS) process is a potential technique that scientists are researching. Existent problems during directly fabricating metal part by use of SLS are analyzed. For the sake of solving the problems, a new idea of adding self-propagating high-temperature synthesis (SHS) material into metallic powder material to form new type of SLS metallic powder material is put forward. This powder material can release controllable amount of heat during its interaction with the laser beam energy to reduce the requirement to laser power during directly sintering metallic part, to prolong the time of metallic liquid phase existing, and to improve the intensity and accuracy of SLS part. For this reason, SHS material′s interaction with the CO2 laser beam energy is researched, which proves that CO2 laser beam energy may instantly ignite SHS reaction. On the basis of the above-mentioned researches, the effect of sintering the metal powder material mixing SHS material with CO2 laser is also researched, which shows: there is an optimal blending ratio of various material in the new metallic powder material. Under the optimal blending ratio and SLS process parameters, this new metallic powder material can indeed release amount of heat and SHS reaction may be controlled within the laser sintering. This research result makes it possible that the metallic part is directly sintered with small CO2 laser (less than 50W), which may greatly reduce the volume, cost and running expenditure of SLS machine, be propitious to application. | Y.S.Shi S.C.Chen X.L.Lu S.H.Huang | 2004 | Acta Metallurgica Sinica(English Letters)2004，17，5： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员