|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Spontaneous combustion liability between coal seams: A thermogravimetric study显示文摘The spontaneous combustion liability of coal can be determined by using different experimental techniques.These techniques are well-known in their application,but no certain test method has become a standard to prove the reliability of all of them.A general characterisation which included proximate and ultimate analyses,petrographic properties and spontaneous combustion tests(thermogravimetric analysis(TGA)and the Wits-Ehac tests)were conducted on fourteen coal and four coal-shale samples.The spontaneous combustion liability of these samples collected between coal seams(above and below)were predicted using the TGA and the Wits-Ehac tests.Six different heating rates(3,6,9,15,20 and 25C/min)were selected based on the deviation coefficient to obtain different derivative slopes and a liability index termed the TGspc index.This study found that coal and coal-shale undergo spontaneous combustion between coal seams when exposed to oxygen in the air.Their intrinsic properties and proneness towards spontaneous combustion differ considerably from one seam to the other.The Wits-Ehac test results agreed with the TGspc results to a certain extent and revealed the incidents of spontaneous combustion in the coal mines. | Moshood Onifade Bekir Genc Samson Bada | 2020 | International Journal of Mining Science and Technology2020，30，5： | 6 |
| 2 | Electrostatic concentration of phosphate flotation concentrate显示文摘The concentration of phosphate flotation concentrate with P2O5 grade lower than the commercially acceptable phosphate quality was upgraded in the use of tribo-electrostatic technique. The concentration of the flotation concentrate stream was conducted under both triboelectrification and inductive charging mechanism. Mineralogical analysis reveals that the phosphate ore utilized was dominated mainly by fluorapatite, crandallite, wavellite, and with quartz as the major gangue mineral. Flotations concentrate of about 28.87% P2O5 was obtained from the reverse flotation technique, after conditioning the phosphate ore at 80% passing 150 lm under Lilafloat. Constant parameters such as à6 kV charging voltage, 25 kV separating voltage, inlet air, different charger rotary speed and splitter distances were investigated. Commercially accepted grade of 35.50% P2O5 was attained after the second stage of separation with a recovery of 12.26%, another phosphate product of 34.02% P2O5 and 85.19% was also recovered under the same condition. Single stage of separation also shows a significant increase in the grade of the product obtained, with 33.41% P2O5 and 84.07% recovery achievable. The practicability of tribo-electrostatic separation technique for upgrading flotation concentrates resulted in a significant increase in grade for <150 lm product that do not meet the viable grade. | Bada Samson Gcanga Sandi Falcon Lionel Falcon Rosemary Makhula Mpho | 2013 | International Journal of Mining Science and Technology2013，23，3： | 4 |
| 3 | Predictions of elemental composition of coal and biomass from their proximate analyses using ANFIS, ANN and MLR显示文摘The elemental composition of coal and biomass provides significant parameters used in the design of almost all energy conversion systems and projects.The laboratory tests to determine the elemental composition of coal and biomass is time-consuming and costly.However,limited research has suggested that there is a correlation between parameters obtained from elemental and proximate analyses of these materials.In this study,some predictive models of the elemental composition of coal and biomass using soft computing and regression analyses have been developed.Thirty-one samples including parameters of elemental and proximate analyses were used during the analyses to develop multiple prediction models.Dependent variables for multiple prediction models were selected as carbon,hydrogen,and oxygen.Using volatile matter,fixed carbon,moisture and ash contents as independent variables,three different prediction models were developed for each dependent parameter using ANFIS,ANN,and MLR.In addition,a routine for selecting the best predictive model was suggested in the study.The reliability of the established models was tested by using various prediction performance indices and the models were found to be satisfactory.Therefore,the developed models can be used to determine the elemental composition of coal and biomass for practical purposes. | Abiodun Ismail Lawal Adeyemi Emman Aladejare Moshood Onifade Samson Bada Musa Adebayo Idris | 2021 | International Journal of Coal Science & Technology2021，8，1： | 1 |
| 4 | Experimental evaluation of activated carbon derived from South Africa discard coal for natural gas storage显示文摘Lacking in literature is the use of discard coal to produce activated carbon and in its subsequent use in the storage of natural gas. In this study, the characterization and gas storage evaluation of a largely porous activated carbon with large surface area synthesized from discard coal were investigated. Discard coals are waste material generated from coal beneficiation process. In developing the activated carbon, chemical activation route with the use of KOH reagent was applied. The effects of KOH/discard coal weight ratio (1:1, 2.5:1, 4:1), temperature (400-800 ℃) and particle size (0.15-0.25 mm, 0.25-0.5 mm, 0.5-1 mm) on the adsorptive properties of the activated carbon were methodically evaluated and optimized using response surface methodology. The synthesized activated carbon was characterized using BET, SEM/EDS, and XRD. The results showed that for each activation process, the surface area and pore volume of the resulting activated carbon increased with increased temperature and KOH/discard coal weight ratio. The maximum surface area of 1826.41 m2/g, pore volume of 1.252 cm^3/g and pore size of 2.77 nm were obtained at carbonization temperature of 800 ℃ and KOH/discard coal weight ratio of 4:1. Methane and nitrogen adsorption data at high pressure were fitted to Toth isotherm model with a predictive accuracy of about 99%. Adsorption parameters using the Toth model provides useful information in the design of adsorbed natural gas storage system. According to the requirements of adsorbent desired for natural gas storage, it could be stated that the synthesized activated carbon could well be applied for natural gas storage. | Jibril Abdulsalam Jean Mulopo Bilainu Oboirien Samson Bada Rosemary Falcon | 2019 | International Journal of Coal Science & Technology2019，6，3： | 1 |
| 5 | Parametric study of electrostatic separation of South African fine coal显示文摘The fact that water requirements are a major problem for present and future developments in material beneficiation, and the construction of a new power plant in South Africa, forms the basis for the utilization of a Rotary Triboelectrostatic Separator (RTS) for beneficiation of South African pulverized coal. The cleaning potential of Majuba and Koorfontein coal was first evaluated using kinetic froth flotation tests on the -177 μm coal fraction. The RTS tests were conducted under varied process parameters. Parameters such as applied separating voltage, air injection velocity, particle feed rate and splitter position were investigated. Two stage separation results show that the RTS reduced Majuba coal initially containing about 30% ash to a clean product of 14.30%, or 19.46%, ash at a combustible recovery of 15.10%, or 53.02%, respectively. Similar separation performance was also achieved with the Koorfontein coal. The mineral and organic compositions in the feed, after single stage and after the second stage separations were characterized using X-ray diffraction analysis. The results show a better separation for the second stage coal products. | BADA Samson TAO Daniel HONAKER Rick FALCON Lionel FALCON Rosemary | 2010 | Mining Science and Technology2010，20，4： | 1 |
| 6 | Systematic physicochemical characterization,carbon balance and cost of production analyses of activated carbons derived from(Co)-HTC of coal discards and sewage sludge for hydrogen storage applications显示文摘Hydrothermal carbonization(HTC)technologies for producing value-added carbonaceous material(hydrochar)from coal waste and sewage sludge(SS)waste might be a long-term recycling strategy for hydrogen storage applications,cutting disposal costs and solving waste disposal difficulties.In this study,hydrochars(HC)with high carbon content were produced using a combination of optimal HTC(HTC and Co-HTC)and chemical activation of coal tailings(CT),coal slurry(CS),and a mixture of coal discard and sewage sludge(CB).At 850℃and 800℃,respectively,with a KOH/HC ratio of 4:1 and a residence time of 135 min,activated carbons(ACs)with the highest Brunauer–Emmett–Teller specific surface(S_(BET))of 2299.25 m^(2)g^(−1)and 2243.57 m^(2)g^(−1)were obtained.The hydrogen adsorption capability of the produced ACs was further studied using gas adsorption isotherms at 77 K.At 35 bars,the values of hydrogen adsorbed onto AC-HCT(AC obtained from HTC of CT),AC-HCS(AC obtained from HTC of CS),and AC-HCB(AC obtained from HTC of the blending of coal discard(CD)and SS)were approximately 6.12%,6.8%,and 6.57%in weight,respectively.Furthermore,the cost of producing synthetic ACs for hydrogen storage is equivalent to the cost of commercial carbons.Furthermore,the high proportion of carbon retained(>70%)in ACs synthesized by HTC from CD and SS precursors should restrict their potential carbon emissions. | Gentil Mwengula Kahilu Samson Bada Jean Mulopo | 2023 | Waste Disposal and Sustainable Energy2023，5，2： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员