4篇
您的检索式：作者名="HAMED RASHIDI"
|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | Improving methane storage on wet activated carbons at various amounts of water显示文摘Different mesoporous activated carbons were prepared by both chemical and physical activation processes and were examined for methane uptake in the presence of water.Methane isotherms were obtained at wet condition by wetting samples with water at mass ratio of water/carbon(R) close to 1.0.To compare,the amount of methane storage were also measured at dry situation.The maximum amount of methane stored was attained as 237 V/V at R=1.0 by hydrate formation at the methane critical pressure.In the next step,mass ratios of water/carbon were changed to investigate various amount of water for methane storage enhancement.Two other values of mass ratio of water/carbon(R=0.8 and 1.4) were selected and methane isotherms were obtained at the same conditions.Maximum values of 210 and 248 V/V were reached for methane storage,respectively.It was also observed that,in the pressure range lower than hydrate pressure,by increasing water ratio the hydrate formation pressure was decreased and methane uptake was much less than that of dry condition due to pore filling by water. | MOHAMMAD JABER DARABI MAHBOUB ALI AHMADPOUR HAMED RASHIDI | 2012 | 燃料化学学报2012，40，4： | 7 |
| 2 | Inverted polymer solar cells with employing of electrochemical-anodizing synthesized TiO_2 nanotubes显示文摘An inverted structure of polymer solar cells based on Poly(3-hexylthiophene)(P3HT):[6-6] Phenyl-(6) butyric acid methyl ester(PCBM) with using thin films of TiO_2 nanotubes and nanoparticles as an efficient cathode buffer layer is developed. A total of three cells employing TiO_2 thin films with different thickness values are fabricated. Two cells use layers of TiO_2 nanotubes prepared via self-organized electrochemical-anodizing leading to thickness values of 203 and 423.7 nm, while the other cell uses only a simple sol–gel synthesized TiO_2 thin film of nanoparticles with a thickness of 100 nm as electron transport layer. Experimental results demonstrate that TiO_2 nanotubes with these thickness values are inefficient as the power conversion efficiency of the cell using 100-nm TiO_2 thin film is 1.55%, which is more than the best power conversion efficiency of other cells. This can be a result of the weakness of the electrochemical anodizing method to grow nanotubes with lower thickness values. In fact as the TiO_2 nanotubes grow in length the series resistance(Rs) between the active polymer layer and electron transport layer increases, meanwhile the fill factor of cells falls dramatically which finally downgrades the power conversion efficiency of the cells as the fill factor falls. | Mehdi Ahmadi Sajjad Rashidi Dafeh Hamed Fatehy | 2016 | Chinese Physics B2016，25，4： | 1 |
| 3 | Mass transfer investigation and operational sensitivity analysis of aminebased industrial CO_2 capture plant显示文摘In this article, the industrial process of CO_2 capture using monoethanolamine as an aqueous solvent was probed carefully from the mass transfer viewpoint. The simulation of this process was done using Rate-Base model, based on two-film theory. The results were validated against real plant data. Compared to the operational unit, the error of calculating absorption percentage and CO_2 loading was estimated around 2%. The liquid temperature profiles calculated by the model agree well with the real temperature along the absorption tower, emphasizing the accuracy of this model. Operational sensitivity analysis of absorption tower was also done with the aim of determining sensitive parameters for the optimized design of absorption tower and optimized operational conditions. Hence,the sensitivity analysis was done for the flow rate of gas, the flow rate of solvent, flue gas temperature, inlet solvent temperature, CO_2 concentration in the flue gas, loading of inlet solvent, and MEA concentration in the solvent. CO_2 absorption percentage, the profile of loading, liquid temperature profile and finally profile of CO_2 mole fraction in gas phase along the absorption tower were studied. To elaborate mass transfer phenomena, enhancement factor, interfacial area, molar flux and liquid hold up were probed. The results show that regarding the CO_2 absorption, the most important parameter was the gas flow rate. Comparing liquid temperature profiles showed that the most important parameter affecting the temperature of the rich solvent was MEA concentration. | Abbas Hemmati Hamed Rashidi | 2019 | Chinese Journal of Chemical Engineering2019，27，3： | 1 |
| 4 | Photocatalytic Synthesis of Gold Nanoparticles Using Preyssler Acid and Their Photocatalytic Activity显示文摘Preyssler acid H14[NaP5W30O110] was used as reducing agent and stabilizer for the synthesis of gold nanoparticles by photolysis of Au(III)/Preyssler acid/propan-2-ol solution.Preyssler acid plays both the role of transferring electrons from propan-2-ol to Au(III) and stabilizing the nanoparticles.Propan-2-ol was used as sacrificial reagent for the photoformation of reduced Preyssler acid.Gold nanoparticles (Au NPs) were characterized by UV-Vis spectroscopy,transmission electron microscopy (TEM),and particle size distribution (PSD) measurements.The synthesized Au NPs had a uniform hexagonal morphology and their size was about 17 nm.The catalytic performance of these NPs for photodegradation of methyl orange (MeO) was investigated in aqueous solution.UV-Vis studies showed that Au NPs can catalyze photodegradation of this azo dye.The pseudo-first-order rate constants were also calculated for this reaction. | Ali AYATI Ali AHMADPOUR Fatemeh F.BAMOHARRAM Majid M.HERAVI Hamed RASHIDI | 2011 | 催化学报2011，32，6： | 1 |
您所在的机构暂未开通此部分的功能，请联系管理员