| 1 | Polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) emissions from electric arc furnaces for steelmaking显示文摘The proportion of steel produced using electric arc furnaces(EAFs)is increasing.In this study,polychlorinated dibenzo-p-dioxins and dibenzofurans(PCDD/Fs)concentrations and patterns in stack gas samples from three typical EAFs in steelmaking plants were determined to allow the contributions of EAFs in steelmaking plants to PCDD/Fs emissions in China to be assessed.Samples collection was accomplished by adopting the automatic isokinetic sampling technique,then the PCDD/Fs congeners concentrations were analyzed qualitatively and quantitatively by isotope dilution high-resolution gas chromatography high-resolution mass spectrometry(HRGC-HRMS).The mean PCDD/Fs mass concentrations in stack gases emitted during the scrap preheating phase of plants E1,E2,and E3 were 0.48,385.55,and 0.34 ng Nm^-3,respectively,and the total toxic equivalent(WHO2005-TEQ)concentrations were 0.05,33.16,and 0.03 ng Nm^-3,respectively.The PCDD/Fs mass concentration in stack gases emitted during the melting phase at plant E3 was 0.12 ng Nm^-3(0.02 ng WHO2005-TEQ Nm^-3).The operational temperature of the bag filter of the preheating in the E2 EAF was as high as 230℃,which is conducive to the generation of PCDD/Fs,whether the temperature in the bag filter of E1(150℃)and E3(120℃)are not.Moreover,the bag filter temperature is suggested to be best controlled to below 150℃.The emission factors(EF)for PCDD/Fs released into the air during the scrap preheating phase for plants E1,E2,and E3 were 0.13,52,and 0.10 mg WHO2005-TEQ t1,respectively,and the EF for the smelting phase from plant E3 was 0.14 mg WHO2005-TEQ t1.The emission factor in E2 is 5 times higher than the highest current UNEP toolkit factor for EAFs(10 mg TEQ/tonne steel).Therefore,an update for the UNEP toolkit emission factor for a few case plants is suggested.Several congeners,including 2,3,7,8-TeCDF,1,2,3,4,6,7,8-HpCDF,and 1,2,3,4,6,7,8-HpCDD,were dominant during the preheating phase,while 2,3,7,8-TeCDF,1,2,3,7,8-PeCDF,and 2,3,4,7,8-PeCDF were dominant during the smelting phase.The monitoring data from the case plants helps to better understand the PCDD/Fs emissions of EAFs using preheating process stages.However,a more complete emission inventory requires more case investigations on the PCDD/Fs emissions from representative EAFs steelmaking plants. | Qiuting Yang Lili Yang Jia Shen Yuanping Yang Minxiang Wang Xiaoyun Liu Xuejing Shen Changliang Li Jia Xu Fengfeng Li Da Li Guorui Liu Minghui Zheng | 2020 | Emerging Contaminants2020，6，1： | 3 |
您所在的机构暂未开通此部分的功能，请联系管理员