维普中文期刊产品整合服务

Analysis of the cracks formation on surface of extruded magnesium rod based on numerical modeling and experimental verification

查看全文 作　　者：Hongjun [1,3]HU;Dingfei [1,2]ZHANG;Fusheng [1,2]PAN;Mingbo [1,3]YANG 高影响力作者 机构地区：[1]College of Materials Science and Engineering, Chongqing University, Chongqing 400045, China;[2]National Engineering Research Center for Magnesium Alloys, Chongqing 400044, China;[3]College of Material Science and Engineering, Chongqing University of Technology, Chongqing 400050, China高影响力机构 出　　处：《Acta Metallurgica Sinica(English Letters)》索引2009年第22卷第5期,共12页高影响力期刊 基　　金：supported by National Basic Research Program of China(No.2007CB613700);National Sci & Tech Support Program (No.2007BAG06B04);National Natural Science Foundation of China (No.50725413);Plan for the 11th National Five-Year Plan (No.2006BAE04B03);Researches on Mathematical Models of Solidification Segregation in Continuous Casting and Simulation Technologies(No.CST,2007bb4413) 摘　　要：To reduce the surface cracks of extrusion rod for AZ31 magnesium caused by nonho-mogeneous metal flow in extrusion process, 3D computer finite element (FE) simulations of extruding a wrought magnesium alloy AZ31 into rods have been performed and the results have been verified in extrusion experiments under identical conditions. The tendency to generate the dead zone is decreased by employing the die angle 60° at the cone-shaped die comparing with the die angle 180°. The surface additional tensile stresses of the rod at the die exit are decreased greatly so that the surface cracks caused are avoided by using the die angle 60°. The extrusion die with die angle 180° would increase the higher temperature rise and possibility of crack forma- tion on the rod surface that caused by die angle 60° and temperature rise decrease tensile strength of the AZ31 rod. The experimental results show that die angle 180° could cause continuous cracks on the surface of the extruded rod. The extrusion force required is reduced approximately 15 ton by employing the die angle 60°. Theoretical results obtained by the DeformTM-3D simulation agreed well with the experiments. The obtained results provide the fundamental and also practical guidelines for the design and correction of dies to produce magnesium rod with good surface quality. 关 键 词：挤压 有限元分析 镁合金 裂痕
相关文献

参考文献(9)

引证文献(9)

网站首页 | 关于我们 | 联系我们 | 产品服务 | 客服中心 | 广告服务 | 版权声明 | 网站联盟 | 友情链接 | 售卡网点

版权所有© 渝B2-20050021-1　渝公网安备 50019002500403号　违法和不良信息举报中心

互联网出版许可证 新出网证(渝)字10号 全国400电话 - 免长途话费